Click To Call(386) 270-5568Click To Get A Free Estimate
Restored paver driveway with even color and full joints in Flagler Beach

Worn, cloudy pavers made even and sharp again

Paver Restoration and Resealing in Flagler Beach, FL

Call (386) 270-5568 to ask a local contractor about restoring tired pavers, with a free estimate.

  • Brings out deeper paver color
  • Fresh joint sand helps lock pavers in place
  • Gives weeds less room to grow
  • Makes the surface easier to keep clean
  • Free estimate, no obligation

Request a Free Estimate

Free, no obligation.

Step 1 of 2

Where are your pavers?

Please choose one.

Free EstimateNo obligation
Fast ReplyWithin 1 business day, usually much sooner
Typical Local Price$1.50 to $3.00 a sq ft to clean, sand and seal
Call Now(386) 270-5568
Paver restoration

How fast can a paver restoration be quoted in Flagler Beach?

A local contractor can quote paver restoration in Flagler Beach, FL, with a reply inside 1 business day, usually much sooner. Looking at the pavers and pricing the work is free, with no pressure afterward. To get going, call (386) 270-5568.

Restoration is for pavers that need more than a rinse: cloudy sealer, empty joints, stains and fading all at once. The finished surface has even color, packed joints and a clean coat on top. A local contractor also checks the joints and the old coat first, so the quote lists what needs stripping and what only needs a wash. Send a photo of the worst corner or request a free estimate.

Call (386) 270-5568

What is the difference between resealing and a full restoration?

Resealing recoats pavers whose old sealer is worn but still clear. Restoration goes further. Castle Clean and Seal describes it as stripping old sealer, deep cleaning, re-leveling and fresh sealer. A neglected driveway can need every one of those steps. To see which job fits yours, call (386) 270-5568.

A Flagler Beach company also lists washing, rust and efflorescence removal, re-sanding, sealing and repair of damaged pavers as its paver work, which gives a sense of how many separate tasks a restoration can hold. Not every step applies at every house. Ask the contractor to mark which ones your pavers need when you request a free estimate.

How do I know my sealer has failed?

Look for a milky or white cast, patches that peel, spots that look wet when dry and water that soaks in instead of beading. A Volusia County paver company links white haze to solvent sealer applied in humid weather. Western Interlock says hidden moisture makes a coat foggy, especially when sprinklers run. A contractor can test a patch to see what is on the surface. Call (386) 270-5568 for a look.

Cloudy or milky film

Often trapped moisture or humid-weather sealing. The film shows most after rain or when the sprinklers come on.

Peeling or flaking

The coat has lost its bond and cannot be recoated as it stands.

Dark soaked-in patches

Water that darkens the paver instead of beading means the coat is thin or gone.

Sticky or glossy streaks

Uneven application leaves lap marks that stay visible in sun.

Contractor and homeowner examining cloudy old sealer on a paver walkway
Why choose us

Why do coastal pavers wear out sealer so quickly?

Castle Clean and Seal blames constant salt air, intense UV and heavy coastal moisture for fading, joint sand erosion and organic growth, and it notes sand washes out of joints after storms. Flagler Beach gets all of that on a thin strip between the ocean and the Intracoastal Waterway. A Northeast Florida paver company puts coastal homes at the short end of a two to three year reseal range. To plan your next coat, call (386) 270-5568.

Beach homes also change hands and sit empty. The 2020 count shows 27.6 percent of the city's 3,687 housing units vacant, which in a beach city can include second homes. A house closed for months gets no hosing or sweeping, and the coat can fail without anyone noticing. Mention how often the house is lived in when you request a free estimate.

Can failed sealer be stripped and the pavers resealed?

Yes. Western Interlock says that when water based sealer goes wrong, the answer is to strip the pavers back to raw and reseal under proper conditions. For a cloudy solvent based coat, the same source says to test xylene on a small patch before treating the rest, and to use a stripping agent if that does not help. Always test a patch first. To have a contractor test yours, request a free estimate.

A water based sealer cannot go over a solvent based one, so what is already down matters. That is why a quote for restoration should name the old product if it is known and the new one. Call (386) 270-5568 to have those questions answered before work starts.

How it works

What is the paver restoration process in Flagler Beach?

The order protects the result. Pavers are checked, old sealer is stripped if it has failed, and the surface is washed. Joints get fresh sand once the pavers are dry, and Unilock asks for at least 24 hours of drying after cleaning. Sealer goes on last. Castle Clean and Seal applies 2 to 3 coats and says most projects finish in 1 day. To pick a date, call (386) 270-5568.

Heat and moisture decide the sealing window. Western Interlock says sealer may not perform above 90 degrees, a mark pavers in full sun can pass even when the air is near 75. Morning starts and a dryness check help. Ask about the plan when you request a free estimate.

Pricing

What does paver restoration cost in Flagler Beach?

No page read for this site prices restoration as a whole. Castle Clean and Seal lists $1.50 to $3.00 per square foot for the clean, sand and seal, a $1,000 minimum, and no separate price for stripping or leveling. So build the number in pieces and ask for each piece in writing. To get one for your pavers, request a free estimate.

Stripping adds labor, and leveling adds both labor and sand or base. The base range below leaves those out. Call (386) 270-5568 to talk through a quote that seems too high or too low.

Paved areaTypical exampleClean, re-sand and sealStripping old sealer
400 sq ftBack patio$600 to $1,200Not published, ask for it listed apart
600 sq ftTwo car driveway$900 to $1,800Not published, ask for it listed apart
1,000 sq ftPool deck and lanai$1,500 to $3,000Not published, ask for it listed apart
1,500 sq ftDriveway plus pool deck$2,250 to $4,500Not published, ask for it listed apart

The $1.50 to $3.00 per square foot comes from Castle Clean and Seal's Flagler Beach page. That page describes restoration as stripping old sealer, deep cleaning, re-leveling and fresh sealer, but gives no separate price for the stripping or the leveling, so those columns stay open. The same company lists a $1,000 minimum, which can lift a small job above the low end shown.

Get a Free Estimate

Fresh sand packed into a restored paver pattern after stripping and washing

What should I ask before booking a restoration?

Ask what is on the pavers now, how the old coat will come off and which sealer goes down. Ask whether leveling is in the price and how dryness is confirmed. Ask how a surprise shower is handled partway through. Western Interlock lists hidden moisture and surface heat as two main causes of sealer trouble, so those answers matter. Write the answers into the quote and call (386) 270-5568 if any are vague.

The contractor standards page lists what to check before signing. Match each bid to the same list of steps and the comparison gets simple. When ready, request a free estimate.

Photos

How do restored pavers look near the beach?

Freshly sealed paver driveway across from the ocean dunes after a restoration at a Flagler Beach home
Sealed paver pool deck after a restoration at a Flagler Beach home
Sealed paver deck beside a small backyard pool at a beach home after a restoration at a Flagler Beach home
Sealed paver walkway to a front door after a restoration at a Flagler Beach home
Close view of freshly sealed pavers after a restoration at a Flagler Beach home
Paver area with one cleaned half beside a dirty half after a restoration at a Flagler Beach home
Contractor cleaning pavers after a restoration at a Flagler Beach home
Contractor sealing or sanding pavers after a restoration at a Flagler Beach home
Questions

Questions about paver restoration in Flagler Beach

What is the average cost to seal pavers in Florida?

Castle Clean and Seal lists $1.50 to $3.00 per square foot for a full job, with driveways at $1.50 to $2.50 and pool decks at $1.75 to $3.00. It also lists a $1,000 minimum. Restoration that includes stripping and leveling costs more, and no page prices those parts alone. For your number, request a free estimate.

Is there a downside to sealing pavers?

The main one is repeat cost. A coat wears out and has to be renewed, and a failed one has to come off before a new one goes on. Western Interlock says hidden moisture or heat can leave sealer cloudy. Those are the cases that turn a reseal into a restoration.

Can I use Dawn dish soap to clean my pavers?

It is a weak choice. Cleaning guides say it is not meant for a pressure washer, and it does little against algae. A restoration contractor uses cleaners matched to the stain and the paver, then rinses with fresh water.

How often do you need to reseal pavers in Florida?

Unilock gives three to five years for most pavers, and a Northeast Florida paver company puts coastal homes at the short end of two to three years. A splash that darkens the paver and sinks in tells you the coat has thinned out. To have yours checked, call (386) 270-5568.

Why is paver sealing so expensive?

Work before the sealer takes the time. Castle Clean and Seal describes stripping, deep cleaning, re-leveling and fresh sealer in 2 to 3 coats, and most jobs fit in 1 day. Restoration packs more of those steps in, so it prices above a simple reseal.

How much should I pay for paver sealing?

A fair starting range is $1.50 to $3.00 per square foot, from published local prices, plus the extras your pavers need. Ask for the sealer, sand and drying time to be listed on the quote. To compare a bid you hold, call (386) 270-5568.

When can pavers just be resealed, and when must the old coat come off?

A coat that is worn but clear can often be cleaned and recoated. Cloudy, peeling or milky sealer is different. Western Interlock says water based sealer problems call for stripping the pavers back to raw and resealing under proper conditions, and that xylene does nothing on them.

Does solvent based sealer cloud on coastal pavers?

It can. Western Interlock says moisture under the surface leaves sealer foggy, and a Volusia County paver company links white haze to solvent sealer put on in humid weather. A contractor tests a small patch before treating the whole area.

Does a restoration include leveling sunken pavers?

Castle Clean and Seal lists re-leveling inside its restoration description, so ask whether a quote has it. Sealer cannot lift a low paver. If a paver rocks or a puddle stays after rain, mention it when you request a free estimate.

How do I restore pavers after a storm covers them in sand in Flagler Beach?

The sand is swept off first, then the pavers are washed and the joints checked. A hard storm can pile sand on streets well back from the beach. Washed out joint sand has to be replaced before any sealer. To plan a restoration after a storm, call (386) 270-5568.

Service area

Where does a contractor take restoration jobs?

Restoration visits cover Flagler Beach and a long list of towns along the coast and inland. Choose yours for its own page, or call (386) 270-5568 if it is not shown.

Ready to bring your tired pavers back?

Reach out by phone or short form for a free look and a written price, answered within 1 business day, usually much sooner.

Call (386) 270-5568

Free, no obligation