Paver Sealing in New Smyrna Beach, FL

Yes, because a coat helps against fading, green film and washed-out joint sand. Humidity here stays above 70 percent all year, and oak shade keeps some drives damp. Sunken or lifted pavers need repair first. A contractor can explain what your own pavers need during the free estimate. A free estimate is the quickest way to learn what your own pavers need.

Seal once the pavers are clean, the joints are full and the surface is dry. Ask your installer whether the pavers should settle first, because it depends on the product. A contractor can check the surface at the estimate. Even new pavers can need a rinse first, since dust from the install may sit in the seams.

Contractors usually do both. They spray the sealer and then roll it in, so it reaches the joints and spreads evenly. Ask how your contractor applies it. Spraying covers a wide area quickly, and rolling works the sealer into the joints and pushes out puddles. Spraying covers a wide area quickly, and rolling works the sealer into the joints.

Companies on this coast post $1.50 to $3.00 per square foot for the clean, sand and seal. Size, shade growth and old coats move a job within that range. Ask for the total area in writing. Pool decks and tight courtyards sit toward the top of the range, since they take more time. Larger pool decks and long driveways raise the total at the same rate.

Often yes, but the drying stage can make it take a second day. The wash comes first, then drying, then sand, then sealer. The contractor will tell you the plan at the estimate. Rain, a wet morning or a heavy dew can push the sealing step to another day, so keep a back-up date. The contractor will tell you the plan at the estimate, including any wait time for drying.

They can, because shade holds damp, and damp grows green film. Pavers under oaks may need washing sooner than sunny ones. The contractor can judge when a new coat is due from the surface. Trimming low branches can help the surface dry faster, so mention it if you are able. Trimming low branches can help the surface dry faster.

Wash off the silt before sealing, because sealer would lock it in. The contractor checks for lifted pavers and lost sand too. A written estimate lists the surfaces so you can see which ones took the most time.

Most quotes in this area put the gap between coats at two to five years. Scuffs appear sooner on a wet look than on matte. Heavy shade and storm debris can cut that span. Ask the contractor to look at the drive lanes, which show wear first. Mention any peeling so the contractor can plan the strip step.

Yes, with the right product. Natural stone calls for a penetrating finish, and an old coat decides the new one. The contractor tests a small spot first. Mention any peeling or flaking so the contractor can plan the strip step.

Labor and prep make up most of a bill, not the sealer. A job needs washing, drying, sanding the joints and a careful coat, and each step takes time. Posted rates for the full wash, sand and coat sit at $1.50 to $3.00 per square foot.

It helps, because weeds start in open joints where sand has gone and soil has settled. A packed joint under a sealed top gives seeds less to hold onto. Some weeds may still show up along edges.

Yes, on dry days. The rainy season runs May to October, so expect some delays. Early dry-season dates from November to April are easier, and they book up fast.